Knowledgebase
I don't want to do MOPEX passive deblending. Is there a way to turn it off?
Posted by IRSA HelpDesk on 11 March 2013 01:49 PM
The way to avoid doing passive deblending is to remove the deblend_size and deblend_id columns. To do so on the command line, set the following in the namelist:
run_select_detect = 1

and add the list of columns to copy:
select_detect_columns = "srcid,x,y"

In the GUI, you should add the module Select Detect into the flow, and add the columns srcid, x, y in the module settings.

Detect Select will create a new detection table without the deblend_size and deblend_id colummns, and passive deblending will not be performed.
(0 vote(s))
This article was helpful
This article was not helpful

Comments (0)